Table of Contents
Advertisement
b. Remove the disc according to the message appearing on the screen.
6. Turn off the power.
Note:
If the AC power supply is shut out during version-up due to power failure, the version-up is improperly carried out.
In such case, replace the FLASH ROM IC (IC8651) and carry out the version-up again.
9.6.3.
DVD Module P.C.B. reset
• • • • When after replacing FLASH ROM IC or DVD Module P.C.B., FL displays error code "DVD F897". This means the unit is not
initialized properly and the following process needs to be carry out.
• • • • Procedures:
1. Press
on remote control while pressing "STOP" button on the main unit. (To enter into initialization)
2. FL display show "INIT".
3. While still pressing "STOP" button on main unit, press "ENTER" on remote control . (To reset the unit)
4. FL wll display "RESET" before FL display will change to TOC reading again.
5. Power off unit. Unplug the AC cord.
6. Power on the unit. It should be no problem. If problem persist check on the DVD Module P.C.B. or FLASH ROM IC.
SA-VK660GC / SA-VK660GS / SA-VK660GCS / SA-VK660GCT
41
Advertisement
Table of Contents
