Table of Contents
Advertisement
SA-VK660GC / SA-VK660GS / SA-VK660GCS / SA-VK660GCT
9 Self diagnosis and special mode setting
This unit is equipped with functions for checking and inspecting.
9.1.
Service Mode Summary Table
9.1.1.
Service Mode Summary Table (For DVD)
The service modes can be activated by pressing various button combination on the player and remote control unit.
Below is the summary of major checking:
Player buttons
Remote control unit
[STOP]
Note:
An error code will be cancelled if a power supply is turned OFF.
*1: CPPM is the copy guard function beforehand written in the disc for protection of copyrights.
*2: CEC is the consumer electronic control used for high-level user control HDMI-connected devices.
*3: HDCP is the specification developed to control digital audio & video contents transmission for DVI or HDMI connections.
Refer to section 7 (Operating Instruction) for information on the buttons.
9.1.2.
Service Mode Summary Table (For Inspection)
Player buttons
Player/Remote Control Unit Buttons
[STOP]
9.2.
Service Mode Table
By pressing various button combinations on the player and remote control unit can activate the various service modes for checking.
Special Note:
Due to the limitations of the no. characters that can be shown on FL Display, the "FL Display" button on the remote control unit
is used to show the following page. (Display 1 / Display 2).
buttons
[0]
Error code display.
[5]
Jitter checking.
[PAUSE]
Initial setting of laser drive current
[1]
ADSC internal RAM data check.
[3]
CD laser drive current check.
[FUNCTIONS]
DVD laser drive current check.
[6]
Region display and mode.
[7]
Micro-processor firmware version check.
[
]
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer (DV 5.0 LSI IC
(IC8611), FLASH ROM IC, EEPROM and HDMI module.
[8]
DVD (HDMI) module firmware version check.
[MENU]
Communication error display.
[TOP MENU]
ECC error check.
[DISC]
CPPM/CRM keys check.
[ENTER]
DVD (HDMI) Module P.C.B. reset.
[
]
Timer 1 check.
[
]
Timer 1 reset. (while in Timer 1 check)
[
]
Timer 2 check.
[
]
Timer 2 reset. (While in Timer 2 check)
[
]
To enter into self-diagnostic checking.
[1]
DVD/CD Mechanism changer unit reliability
check.
[SINGLE CHANGE]
To unlock the traverse unit for service.
[4], [7]
To enter into Doctor Mode.
Application
Application
22
Note
(Refer to section, "9.2.1 of Service
Mode Table 1" for more information).
(Refer to section 9.2.2 of Service
Mode Table 2 for more information)
(Refer to section 9.2.3 of Service
Mode Table 3 for more information)
(Refer to section 9.2.4 of Service
Mode Table 4 for more information)
(Refer to the section, "9.2.5 Service
Mode Table 5" for more information).
Note
(Refer to section, "9.2.6 of Service
Mode Table 6" for more information).
Advertisement
Table of Contents
