Panasonic AJ- DCP Operating Instructions Manual page 28

Setup Menus
OPERATION
Item
Superimposed
No.
display
154 AUTO BACK
160 MEMORY MODE
161 BGN PRESET
(CTL or TC)
162 END PRESET
(CTL or TC)
163 REPT MODE
180 BATTERY SEL
The underlining denotes the factory mode.
Setting
Superimposed
No.
display
For setting the operation method used for the frame-to-frame continuity
function. (This item activates the AUTO BACK function to rewind the tape
for several seconds in order to ensure a smooth continuity between the
recorded images.)
0000 OFF 0: No AUTO BACK operation.
0001 REC-P 1: In the REC PAUSE mode, the AUTO BACK function is activated, and
the tape stops in the recording standby mode. (When PAUSE is
released, the tape runs up and recording starts.)
0002 ALL 2: In addition to the menu item No.0001 (REC-P) function, the AUTO
BACK function is activated in the REC PLAY mode, the tape runs up
immediately, and recording starts.
For setting the repeat playback mode.
0000 OFF 0: No repeat playback (normal operation).
0001 M-STOP 1: The tape stops near the BEGIN point when it is fast forwarded or
rewound.
0002 REPT1 2: When the tape reaches the END point, it is rewound to the BEGIN point
where it stops.
0003 CONT 3: When the tape reaches the END point, it is rewound to the BEGIN point
and played, and this process is repeated.
For setting the BEGIN point in the repeat playback mode. The counter
display mode is set to either TC or CTL by the COUNTER button.
When the BEGIN point is not set, "--:--:--:--" appears on the display, and
the beginning of the tape serves as the BEGIN point.
For setting the END point in the repeat playback mode. The counter
display mode is set to either TC or CTL by the COUNTER button.
When the END point is not set, "--:--:--:--" appears on the display, and the
tape end serves as the END point.
For setting what image is to be output when the tape returns to the BEGIN
point in the repeat playback mode.
0000 FREEZE 0: The tape returns to the BEGIN point while the playback image at the
END point remains frozen.
0001 BLACK 1: The tape returns to the BEGIN point while the picture remains black.
0002 SW 2: The tape returns to the BEGIN point in accordance with the TAPE/EE
switch setting.
<Note>
If the END point is set at the tape end when "0: FREEZE" has been
selected, the playback image will not be frozen properly. Set the END
point within the range of the tape where images are recorded.
For setting the battery type.
0000 NiCd12 0: 12 V type of battery
0001 NiCd13 1: 13 V type of battery
0002 NiCd14 2: 14 V type of battery
28
Description of setting