Video - Panasonic AJ- DCP Operating Instructions Manual

Setup Menus

VIDEO

Item
Superimposed
No.
display
603 V-MUTE SEL
620 DOWNCON
MODE
645 D/C ENH
672 V OUT SETUP
673 EDH
The underlining denotes the factory mode.
Setting
Superimposed
No.
display
For setting whether to mute the video output signal when a blank part of
the tape has been detected during playback.
0000 N-MUTE 0: The video output signal is not muted (the image is frozen).
0001 GRAY 1: The video output signal is muted (the screen is turned gray).
For setting the image processing which is to be performed during down-
conversion.
0000 FIT_V 0: Side cut mode
0001 FIT_H 1: Letter-box mode
0002 FIT_HV 2: Squeeze mode
0003 14:9 3: Semi letter-box mode 14:9
0004 13:9 4: Semi letter-box mode 13:9
<Note>
While the setting is being adjusted, the sound output will be muted;
however this is normal and not indicative of a problem. When the
adjustment is finished, sound will be output.
For setting whether to enhance the contours during down-conversion.
0000 OFF 0: The contours are not enhanced.
0001 ON 1: The contours are enhanced.
For setting the setup processing for the composite output signal.
0000 THRU 0: The original signal is output as is.
0001 ADD22L 1: A 7.5% setup is added from line 22 of the output signal and output.
0002 ADD21L 2: A 7.5% setup is added from line 21 of the output signal and output.
0003 ADD20L 3: A 7.5% setup is added from line 20 of the output signal and output.
For setting whether to superimpose EDH onto the SD SDI output.
0000 OFF 0: EDH is not superimposed.
0001 ON 1: EDH is superimposed.
32
Description of setting