Basic - Panasonic AJ- DCP Operating Instructions Manual

Setup Menus

BASIC

Item
Superimposed
No.
display
001 LOCAL ENA
002 TAPE TIMER
003 REMAIN SEL
005 SUPER
006 DISPLAY SEL
007 CHARA H-POS
008 CHARA V-POS
The underlining denotes the factory mode.
<Notes>
O If the PAGE button and the DATA+ or DATA– button are pressed together when menu item No.007
(CHARA H-POS) and No.008 (CHARA V-POS) are being set, the counter display appears temporarily
while these buttons are held down to enable the settings to be checked.
It is also possible to use the DATA+ button and DATA– button while holding down the PAGE button to
perform the settings while at the same time checking their actual status.
O Even when "OFF" is selected as the menu item No.005 (SUPER) setting, the superimposing is
displayed in accordance with the menu No.006 (DISPLAY SEL) setting while the menu settings are
being performed. When the menu setting process is exited, the display accords with the menu item
No.005 (SUPER) setting.
Setting
Superimposed
No.
display
For setting the buttons which can be operated on the front panel when the
LOCAL/MENU/REMOTE switch is at the REMOTE position.
0000 DIS 0: No buttons can be operated.
0001 ST&EJ 1: Only the STOP and EJECT buttons can be operated.
0002 ENA 2: All the buttons can be operated except for COUNTER and RESET.
For setting the time system on the CTL counter display.
0000 ±12h 0: 12-hour system
0001 24h 1: 24-hour system
For setting the superimposing of the remaining tape time and total tape
length displays for the VIDEO OUT2 connector.
0000 OFF 0: No superimposed displays
0001 2L 1: Remaining tape time is displayed on the second line.
0002 1L 2: Remaining tape time is displayed on the first line.
0003 R/TTL 3: Remaining tape time is displayed on the first line and the total tape
length on the second line.
<Notes>
O When "2L" has been selected as this item's setting, the time will not be
displayed even if "TIME" was selected as the menu item No.006
(DISPLAY SEL) setting.
O Even when "R/TTL" has been selected as this item's setting, the total
tape length will not be displayed if "TIME" has been selected as the
menu item No.006 (DISPLAY SEL) setting.
For setting whether the displays are to be superimposed onto the VIDEO
OUT2 connector.
0000 OFF 0: The displays are not superimposed.
0001 ON 1: The displays are superimposed.
For setting what displays are to be superimposed onto the VIDEO OUT2
connector.
0000 TIME 0: Only the time display is superimposed.
0001 T&STA 1: The time and operation status are superimposed.
0002 T&S&M 2: The time, operation status and mode are superimposed.
<Note>
When "T&S&M" has been selected as this item's setting and a warning or
error occurs, an error message is superimposed.
0000 0 For setting the horizontal position where the superimposed display is to
: : appear.
0006 6
: :
0037 37
0000 0 For setting the vertical position where the superimposed display is to
: : appear.
0023 23
: :
0032 32
25
Description of setting