Krups C Z2 Manual page 6

Hide thumbs Also See for C Z2:
Table of Contents

Advertisement

CoFFEE PREPARATIoN/
PREPARATION DU CAFE
1. Rinse then fill
the water tank with
potable water.
1. Rincer, puis
remplissez le réservoir
avec de l' e au potable.
3. Lift the lever completely
and insert a Nespresso
capsule.
3. soulevez le levier
complètement et insérez
une capsule Nespresso.
5. Press the Espresso (40 ml) or the Lungo (110 ml) button to
start. Preparation will stop automatically. To stop the coffee
flow or top up your coffee, press again.
5. Appuyez sur le bouton Espresso (40 ml) ou le Lungo (110 ml)
pour démarrer. La préparation s'arrête automatiquement. Pour
arrêter l' é coulement du café ou l'allonger, appuyez à nouveau.
5870_UM_ESSENZA-C_Z2_MASTER_2012_KRUPS_v5.indd 10-11
2. Press the Espresso
Blinking Lights: heating
or Lungo button to
up (25 sec)
activate the machine.
Voyants clignotants:
2. Appuyez sur le
préchauffage (25 sec)
bouton Espresso ou
Lungo pour activer la
Steady Lights: ready
machine.
Voyant allumé en
continu: prêt
4. Close the lever and
cauTiON: never lift lever during operation and refer to the safety
place a cup under the
precautions to avoid possible harm when operating the appliance.
coffee outlet.
NOTE: during heat up, you can press either coffee button while blinking.
4. Fermez le levier et
The coffee will then flow automatically when the machine is ready.
placer une tasse sous
aTTENTiON: ne jamais lever la poignée pendant le fonctionnement
la sortie café.
et se référer aux consignes de sécurité pour éviter tout dommage.
REmaRquE: lors du préchauffage, vous pouvez appuyer sur l'un des
deux boutons de café clignotants. Le café s' é coule alors automatiquement
lorsque la machine est prête.
6. Remove the cup. Lift and close the
lever to eject the capsule into the used
capsule container.
6. Retirer la tasse. soulevez et fermez
le levier pour éjecter la capsule dans
le bac à capsules usagées.
PROGRAMMING THE WATER VOLUME/
PROGRAMMATION DU VOLUME D'EAU
1. Turn the machine on and
wait for it to be in ready
mode (steady lights).
1. Mettez la machine sous
tension et attendez qu' e lle
soit en mode prêt (Voyant
allumé en continu).
4. Press and hold the
5. Release button once the desired
Espresso or Lungo button.
volume is served.
4. Appuyez et maintenez
5. Relâchez le bouton une fois que
enfoncé le bouton
le volume désiré est atteint.
Espresso ou Lungo.
2. Fill the water tank with
3. Place a cup under
potable water and insert a
the coffee outlet.
Nespresso capsule.
3. Placez une tasse
2. Remplir le réservoir
sous la sortie café.
d' e au avec de l' e au potable
et insérer une capsule
Nespresso.
6. Water volume level is now stored.
6. Le niveau du volume d' e au est
maintenant mémorisé.
EN FR
10 11
02.04.12 17:32

Advertisement

Table of Contents
loading

Table of Contents