Configuring The Indicator View - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.8.3 Configuring the indicator view

Indicator
Indicator
Totalizer / statistics
Bar graph display
Alarm Trip Points
Menu enables
84
Select On to enable the Operator to display the Indicator view.
Set to On to add the channel totalizer value and units to the Indicator
view.
Note. Available only if the totalizer option is enabled in the software
totalizer for that channel is enabled.
Set to On to add the Bargraph display to the Indicator view.
Note. Bargraphs are displayed only for groups with a maximum of 6
recording channels.
Set to On to add the alarm trip point indicators to the bargraphs.
Select the menu items to be accessible from the Indicator view.
Operator message
Totalizer stop / go
Totalizer reset
Show totalizers / statistics
Alarm acknowledge
Note. Menu items that are not enabled are greyed-out in the Indicator
view menu.
– Enables the Operator to activate one of
24 pre-configured messages or a
user-defined message.
– Enables the Operator to start and stop
the totalizers.
– Enables the Operator to reset the
totalizer value to the preset totalizer value
on any or all channels.
– Enables the Operator to change the
display to show either the totalizer values
or the totalizer maximum, minimum and
average values.
– Enables the Operator to acknowledge
any alarms associated with the current
group.
7 Configuration
a
and
OI/RVG200-EN