ScreenMaster RVG200
Paperless recorder
Tag
Stop/Go/Reset
Stop/Go recovery
Stop/Go source
Reset source
Target Temp/Z Value
Target Temperature
Z Value
OI/RVG200-EN
Enter the F
tag to be displayed in the Indicator view and the Totalizer log
0
(6 characters maximum).
Refer to Appendix F, page 180 for further information regarding character
use in tags.
Note. The default tag text includes 'F
Totalizer log but this can be changed.
Select the action following a power failure and a digital signal to stop and
start the F
value calculation:
0
Last
–
on power recovery, the F
same state as before the failure, either stopped or running.
Stop
–
F
value calculation stops.
0
Go
–
F
value calculation continues from the last recorded value.
0
Select a signal source to stop and start the F
Appendix A, page 146 for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to active) starts
the calculation. A falling edge (active to inactive) stops the calculation.
Start
Stop
Select a signal source (see Appendix A, page 146) – an edge-triggered
signal to reset the calculation on a rising edge.
Default values for the target temperature and Z factor are pre-configured
but can be changed.
Enter the required target temperature.
Enter the required Z value.
7 Configuration
' to distinguish an F
0
value calculation continues in the
0
value calculation; Refer to
0
value in the
0
109