Caslon Zip21A Operation And Maintenance Manual page 14

24 Business Cards to view, 85x54mm, (3 columns of 8) on an SRA3 sheet.
Top Margin 6mm
Business Card Height 54mm
Cross Cut Gutter 0mm
Mark registration
Action
Turn Zip21A on
Press "Cutting Data"
Press "Edit"
Press "Mark/Edge button"
Press "No of cards button"
Press "Margin button"
Press "Card Length button"
Press "Gutter Length button"
Press "Last Cut Offset button"
Press "Job Name button"
Press "Card Size button"
Press " Edit"
Press "Save"
Press "Save" again
Press " Main Page"
: The recommended trim off from the tail edge of the sheet is between 4mm – 10mm
(0.160" - 0.3937"). Tail edge trim off that is too long may hang up in the guillotine causing the
Zip21A to display an error. If this occurs, turn the power "OFF". Remove the top guard and
remove the tail edge trim off scrap. Assure that the recommended tail trim off dimension is
established when laying out the sheet prior to printing.
: The Zip21A paper handling rollers that convey the stock through the machine are
designed to handle a specific thickness of paper. If the paper is thicker or thinner, there may be
a slight difference in the programmable cut off length. If the paper is thicker, the cut off length
is usually longer. If the paper is thinner, the cut off length is usually shorter. After running the
first sheet, check the cut off size and make any adjustments required in the program.
: Due to the feed system of the Zip21A, the last card cut can sometimes be slightly
longer than the others. This is also affected by the thickness of the paper; the thicker the
paper, the bigger the difference. To overcome this adjust the 'Last Cut Offset button' to the
desired value.
Page 13
Operation
Machine will initialise and display operating screen.
Machine opens current job for editing
Edit button flashes and program settings can be adjusted
Selects Lead Edge or Registration Mark
Displays a keypad, press 8 and then return arrow
Displays a keypad, press 6 and then return arrow
Displays a keypad, press 54 and then return arrow
Displays a keypad, press 0 and then return arrow
This is normally set at -0.01
Displays a keypad, press selection and then return arrow
Displays a keypad, enter ZIP21A DEMO SHEET and then
return arrow
Displays a keypad, enter 85x54 MM 24 UP and then return
arrow
Edit button stops flashing
Dislay shows memory store locations. Select the location
required.
Screen returns to the editing screen
Returns to main operating screen with job recalled and
displayed