Cross Cutting / Guillotine Section (change template)
The Zip21A uses a touch screen programmable controller and a guillotine cutter to cut the
sheet into sections. The programmable controls are easy to set-up and adjust. Scissor or gutter
cut formats can be programmed and produced on the Zip21A.
Refer to the Programming Section for set up.
The Cross Cutting / Guillotine
Section is factory set and should not require adjustment. Make sure only qualified engineers
carry out adjustments to this part of the Zip21A.
Note:
If the Gutter cut is not a straight scissor cut it must be 2mm or larger.
Page 9