Caslon Zip21A Operation And Maintenance Manual page 11

Programming
The program requires six pieces of information to be entered before a job can be run.
"Registration" = The mode of operation for registering the start of the cutting process. This can
be either from the LEAD EDGE of the sheet or from a registration MARK printed on the sheet.
"No of Cards" = The number of pieces to be cut out along the length of each sheet.
Note:
If you are running three rows of seven-up business cards on the sheet then the value of "No of
Cards" would equal 7.
"Margin:" = The space between the trail edge of the registration mark and the first cut or the
lead edge of the sheet and the first cut..
Note:
If the first cut is 12mm from the trail edge of the registration mark then the value of "Margin:"
would equal 12.00. Likewise, if the first cut is to be 18mm from the lead edge of the sheet then
this value would equal 18.00.
"Card Length:" = The length of each piece to be cut out along the length of each sheet.
Note:
If you are producing a 50mm high business card then the value of "Card Length:" would equal
50.00
"Gutter Length" = The size of gutter to be removed between each individual piece on the sheet.
Note:
If you are using a 3mm gutter between business cards to remove a bleed then the value of
"Gutter Length" would equal 3.00. If a gutter is not required then the value of "Gutter Length"
would equal 0.00
"Last Cut Offset" = Adjusts the length of the last card cut.
Note:
The last card from each sheet can sometimes be longer than the others. If this is the case, the
last card can be reduced by using this adjustment. Remember to enter a value preceded by a
minus sign or the card will be made longer!
Page 10