Epson Stylus pro 4000 Setup Manual page 8

Attaching the spindle to the printer
To attach the paper loaded spindle to the printer,
follow these steps.
1. Open the roll paper cover.
2. Raise the roll paper support.
3. Make sure that the movable flange is fixed into
the end of the roll paper properly.
4. Hold the roll paper spindle so that the black
movable flange is on the left side. Then place
the spindle on the groove on top of the printer
once.
8
5. Move the paper lever to the released position.
6. Hold the both sides of the paper, and load the
paper into the paper insertion slot.
7. Pull the paper until it hangs down over the
paper tray.
Note:
If you load thin paper, press the Paper Feed
button to decrease the value of paper suction. If you
load thick and curled paper, press the Paper Feed
button to increase the value of paper suction.