Dry Cutter Safety; Description, Specifications And Standard Equipment Description; Specifications; Standard Equipment - RIDGID 614 Operator's Manual

614 Dry Cut Saw
WARNING
Fingers, hands, arms or other body parts can be
cut.
• Wear safety glasses and ear protection.
• Keep hands out of path of saw blade.
• Do not operate saw without guards in place.
• Do not perform any operation freehand.
• Never reach around saw blade (or never reach in
back of saw blade.
• Switch tool off and unplug power cord from recep-
tacle before servicing or adjusting the saw.
READ ABOVE WARNING CAREFULLY!

Dry Cutter Safety

1. Keep all guards in place and in working order.
Damaged guards increase risk of injury.
2. Always clamp the workpiece with vise. Prevent
loss of control of the workpiece.
3. Workpiece must be cut-off against the direction
of the saw only. Prevents workpiece from being
thrown.
4. Be sure cut-off saw is sharp and free from
vibration. Less likely to bind and lose control.
5. Raise the cut-off saw from the kerf of the work-
piece prior to releasing the trigger switch. Less
likely for saw blade to bind.
6. Allow motor to reach full speed before cutting.
Prevents stalling of motor.
7. Use only cut-off saw blade with speed rating at
least as high as the RPM specified on the
nameplate. Improper blade may be hazardous and
result in injury.

Specifications

Blade Size No Load Speed
14" x .087" x 1"
4
Voltage
1300RPM 115V
Ridge Tool Company • Elyria, Ohio • U.S.A.
8. Don't place either hand in the working area
when tool is connected to receptacle. Increases
the risk of injury.
9. Never clamp or tie guard in the open position.
Exposed blade increases the risk of injury.
10. Use proper extension cord. When using an
extension cord of 25 ft. or less use a 14 AWG cord,
for cords up to 50 ft. use a 12 AWG cord. Use of
cords over 50 ft. is not recommended. Use of any
other extension cord will result in deterioration of
tool performance.
SAVE THESE INSTRUCTIONS!
Description, Specifications and

Standard Equipment

Description
This saw has been designed to cut several materials
and geometric configurations, including:
1. Lining tube, gas pipe, electrical wire pipe, steel
pipe, PVC pipe & all kinds of metal pipe.
2. Angle steel, channel steel, steel bar & bolt.
3. Aluminum frame, curtain rail & all kinds of interior
decoration material.
Capacity
Model 614 Capacity Chart
Cutting
Angle
90˚ Cuts 5"
130mm
45˚ Cuts
4"
100mm
Standard Equipment
• Dry Cut Saw
• 14" Blade (Installed)
• Two (2) Allen Wrenches
Hz Ampere
50-60 Hz 15A
Workpiece Geometry
3-3/4" x 7" 4-1/2" x 4-1/2"
95mm x 180mm 115mm x 115mm
3-1/2" x 4" 3-1/2" x 3-1/2"
90mm x 100mm 90mm x 90mm
Net Weight Power Supply Cord
49 lbs. 8.2 ft. (2.5M)