DEK 265 horizon Engineering Specification page 39

MultiFlex
Chapter Issue 1 May 00
The MultiFlex tooling plate hardware consists of a hollow box constructed from
four adjustable side plates. The side plates are secured to the MultiFlex tooling
plate using magnets. The tooling plate is located on the tooling table by means of
dowels.
Board support is provided by double ended steel pins on a 5mm matrix. One end
is 3mm tapering down to 1mm to allow for support of densely populated boards.
The MultiFlex tooling plate is 14 inches x 10 inches. The tooling height is the
same as a standard magnetic tooling pin, ie 81mm.
The 3mm diameter tooling pins are placed on the 5mm pitch matrix according to
the particular board configuration, to support the board, and yet miss any
components, or features present.
Vacuum hold of the board whilst being printed is optional.
Engineering Specification
ENGINEERING SPECIFICATION
MACHINE OPTIONS
33