DEK 265 horizon Engineering Specification page 37

Dedicated Tooling
Chapter Issue 1 May 00
The Dedicated Tooling system is uniquely tailored to fully support the board
whilst being printed. The system consists of the following elements:
Plate Assembly (1) - consists of an upper and lower section. The upper
•
section is machined using customer gerber files and componet profile data to
accommodate underside board components. The lower section can be
rebated to accommodate a chamber to supply vacuum hold to the board
during printing.
• Tower (2) - provides support to the plate assembly at the standard tooling
height of 81mm. The tower is located on the tooling plate by means of
dowels and is secured to the tooling plate by magnets. The tower is available
in 2 widths, 3 inches, 5 inches and 2 heights, standard tooling height and an
AutoFlex option.
• Magnetic tooling pins (3) - provides support for the plate assembly for wider
boards.
NOTE
Numbers in brackets refer to figure below.
1
Engineering Specification
ENGINEERING SPECIFICATION
MACHINE OPTIONS
3
2
31