DEK 265 horizon Engineering Specification page 34

ENGINEERING SPECIFICATION
MACHINE OPTIONS
Foil-less Clamps
28
This option is used on thin boards when there is a requirement to print close to
the edge of the board for traditional board clamps. The board is secured during
the print stroke by the use of vacuum. The clamps are perpendicular to the board
maintaining a good gasket between the stencil and the board. The clamps are
adjusted in height for differing thickness' of board by two grub screws.
Board
Vacuum Box
Engineering Specification
Foil-less Clamp
Adjustment Grub Screw
Rail
Chapter Issue 1 May 00