DEK 265 horizon Engineering Specification page 38

ENGINEERING SPECIFICATION
MACHINE OPTIONS
Dedicated Tooling
Plate
32
The dedicated tooling plate is a 3 piece construction comprising two vertical
supports and a flat top board support. It is manufactured to the same height as the
magnetic pins irrespective of board thickness, ie 81mm (+0.00mm, -0.05mm).
The assembly has dowel registration and is held in position on the manual
tooling plate by magnets located on the vertical supports. If required the top
plate can be machined to accommodate underside components.
81.00mm
+0.00/- 0.05mm
3mm x 10mm Dowel Pins
2.5mm +/- 0.1mm From
Front Edge
80mm +/- 0.05mm
For correct design of tooling, the following rules apply:
Tooling Box Outline
Board Length Nominal
Formulae
Width of Tooling = (Board width - 12mm)
Length of Tooling = (Board Length - 4mm)
Engineering Specification
Between Centres
3.5mm +/-0.2mm
Board Width
Tooling Box
Nominal
Outline
Chapter Issue 1 May 00