Station Programming Instructions - Panasonic KX-TA624 User Manual

2.1

Station Programming Instructions

Station Programming allows you, the proprietary telephone (PT) user, to program certain
features from your telephone individually. To program, you need to switch your telephone
to the Station Programming mode. During the programming mode, your telephone is
busy to outside callers. If you want to make a normal call operation, you must finish the
programming mode.
Programming Mode Display
When you enter the Station Programming mode, the display shows the following message
as the initial programming mode.
PITS-PGM NO?
The display also gives you helpful or stored data information related to the programming
steps. In this section, the display example in the programming steps are noted, if required.
You can also refer to the "Display Examples" in the Appendix (Section 5).
To enter the Station Programming mode
PT
Be sure the telephone is idle and on-hook.
To exit the Station Programming mode
PT
When the display shows the initial programming mode
When storing data
After pressing the STORE button to store data, you may hear one of the following tones.
— Confirmation tone (one beep): storage is completed.
— Confirmation tone (two beeps): the data is the same as the last entry.
— Alarm tone (three beeps):
2-2
Station Programming (Personal Programming)
MEMORY
SET PROGRAM
Set the MEMORY switch to "PROGRAM".
MEMORY
SET PROGRAM
Set the MEMORY switch to "SET".
Programming is completed
and the normal call operation
resumes.
the entry is not valid.