Basic Call Features; Making A Call; Making A Call Via Specific Trunk - Win eNet660S-ENIP2061 User's Reference Manual

Basic Call Features

Operation

Making a Call

Making a Call via
Specific Trunk
ENIP2061 Quick Reference Operating Guide
1.
2.
3.
4.
There are three mode to establish a call for this IP phone, handset
mode, hands-free mode and headset mode. In this manual, only the
handset mode is used for example. In the following features, you can
replace to hands-free mode by pressing
mode by pressing
over, press
please prepare a headset first.
1.
2.
3.
4.
Description
Pick-up the handset. You will hear dial tone.
Use the keypad to dial a phone number. Press
the ENTER key or "Dial" softkey to dial out
immediately, or wait for the Dial Timeout setting
to auto-end the dialing. The Phone will then send
out the dialed number to eNet660S. The
eNet660S will route the call to the appropriate
destination.
Note: You can use the "Backsp" softkey to
delete any digits entered.
Start talking to called party.
Place the handset On-hook when you finished
the conversation.
and
key again to release call. For headset mode,
Pick-up the handset. You will hear dial tone
played.
Press a line key. The LED of line key will light
and the specific trunk line will be engaged. Use
the keypad to dial the target phone number.
Press # key to dial out immediately, or wait for
the Dial Timeout setting to auto-end the dialing.
User can also dial the PSTN or IP trunk access
number which the eNet660S registered.
detail about IP and PSTN trunk, refer to the
eNet660S manual.
Note: You can use the "Backsp" softkey to
delete the last digit.
Start talking to the called party.
Page 19 of 35
key or headset
key. When the conversation is
For