Advertisement
3. Power
The router requires an external DC power supply. The DC voltage required is between
+9 to +36 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the PWR connector on the front panel of the router (see
figure below).
4. Ethernet
An Ethernet cable may be connected to the ETH connector (designated as ETH0 in some
versions of this router) on the front panel (see figure above). By default, the Ethernet port is
configured as follows:
Connector
Purpose
ETH
LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
3
QSG issued in CZ, May 10, 2016
START GUIDE
Advertisement
