Signal Setting - Siemens WT45N200GB Installation And Operation Instructions Manual

Signal setting

en
M
Signal setting
You can change the following settings:
S i g n a l s e t t i n g
The spin speed that is used for
■
spinning your laundry before it is
dried,
The volume of the audible signal at
■
the end of the program,
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
Switch the dryer on.
1.
Select the "Cottons" programme in
2.
position 1 and wait for five seconds.
The symbols go out in the display panel
and the programme duration is
displayed.
Press and hold the Start button and,
1.
at the same time, turn the
programme selector clockwise to
position 2.
The spin speed is shown in the
2.
display.
Press the "Finish in" time button or
3.
the drying time button to change the
spin speed.
Turn the program selector clockwise
4.
to position 3.
26
The volume of the audible signal at
5.
the end of the program is shown in
the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Finish in" time button or
6.
the drying time button to change the
volume.
Turn the program selector clockwise
7.
to position 4.
The volume for the audible button
8.
signal is shown in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Finish in" time button or
9.
the drying time button to change the
volume.
Exiting setting mode
Turn the program selector to the "Off"
position once you have set the required
spin speed and the volume. The
settings have now been saved.