Signal Setting - Siemens WT45H2B8DN Installation And Operating Instructions Manual

M

Signal setting

You can change the following settings:
S i g n a l s e t t i n g
The spin speed that is used for
■
spinning your laundry before it is
dried,
The volume of the audible signal at
■
the end of the programme,
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
Switch the dryer on.
1.
Select the "Cottons" programme in
2.
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
Press and hold the Start button and,
1.
at the same time, turn the
programme selector clockwise to
position 2.
The spin speed is shown on the
2.
display.
Press the "Ready in" time button or
3.
the drying time button to change the
spin speed.
Turn the programme selector
4.
clockwise to position 3.
The volume for the audible signal at
5.
the end of the programme is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
6.
the drying time button to change the
volume.
Turn the programme selector
7.
clockwise to position 4.
The volume for the audible button
8.
signal is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
9.
the drying time button to change the
volume.
You can select other positions
Note:
with the programme selector; however,
you will be unable to change these
settings.
Finishing setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed and the volume.
The settings have now been saved.
Signal setting
en
27