ULTRAFRYER PD14 Operation Instructions Manual page 29

7. PRODUCT LED
a.
b.
8. PRODUCT COOK AND PROGRAMMING KEY
a.
b.
9. PROGRAMMING KEY
In "programming" mode, used to enter the numerical value of 9.
10. DISPLAY
Displays modes, functions and operation of the computer.
11. TOGGLE/PROGRAMMING KEY
In "programming" mode, used to enter the numerical value of 0 and "toggle" (switch) between choices being displayed.
B. DISPLAY DESCRIPTIONS
ACT --- F/C
:
---
BOIL --
OFF
TURN OFF
TOO LOW
TOO HIGH
CK 1-8
STIR 1-8
MELT E
MELT G
MELT P
30A215-Mar2008
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
BLINKING fast in "operating" mode indicates cooking of that product is in process.
When lit (bright) in "programming" mode indicates the product being programmed.
In "operating" mode, used to start and stop a product cook cycle.
In "programming" mode, used to enter numerical value "3660" and select RECIPE PROGRAMMING MODE.
The actual shortening temperature in degrees Fahrenheit/Celsius when the
is pressed, i.e.., 100˚F (38˚C).
---
Time remaining in a cook cycle or other computer function, ie., 10:00.
Time remaining in the BOIL mode, ie., 20:00.
:
--
Indicates the Computer is ready to be turned ON.
NOTE: Computer must be turned OFF by the ON/OFF key before the ON/OFF key
Prompt to cycle power OFF at the end of the BOIL, FILTER, etc., functions
Indicates an entered value is too low and is NOT ACCEPTABLE.
Indicates an entered value is too high and is NOT ACCEPTABLE.
Indicate the specific Product Key number for which the computer is displaying status
information during a cook cycle.
Indicates an action needs to be taken on a product being cooked by a specific product
key such as STIR 5.
Default Electric Melt Cycle - Heating mechanism is ON 4 seconds and OFF
36 seconds.
Default Gas Melt Cycle - Heating mechanism is ON 8 seconds and OFF
32 seconds.
Default Purge Melt Cycle - Heating mechanism is ON 12 seconds and OFF
28 seconds.
can be used to turn the Computer ON.
29
key
.