Ethernet Connection And Factory Reset - Russound XZone4 Installation Manual

ETHERNET CONNECTION AND FACTORY RESET

Ethernet Connection
The Ethernet connection is used for configuration and audio streaming as well as
for enabling control via the MyRussound App or the XTS Touchscreen. The default
network setting is DHCP-enabled, but the XZone4 can be configured with static IP
addressing using Web Config. The Ethernet connection is also used for the built-in
streaming services and for playing any music stored on connected network drives
using DLNA.
Note: While the XZone4 has a single physical Ethernet connection, it will occupy
a total of 5 IP addresses on the network. One address is for XZone4 management,
and there are four other addresses, one for each of the internal streaming modules
that the XZone4 utilizes to provide independent streaming audio content to each
zone. If using DHCP, all 5 addresses will use DHCP. If using static IP addressing, all
5 addresses will need to be configured with a static address.
Factory Reset
The factory reset button has two functions. A 3-second press and hold will restore
network settings to DHCP. A 10-second press and hold will reset the XZone4 to its
factory default settings. When performing either of these functions, do not power
off the XZone4. It will reboot automatically on its own at the proper time. The
entire reset may take several minutes. The XZone4 status LED will illuminate green
when the process is complete.
The factory reset deletes all configuration and personal information including
service account settings and passwords.
Note: After a factory reset, the XZone4 will require valid Russound Certified
Installer credentials in order to be unlocked and configured again.
Installation
Clearance Requirements
When installing the XZone4, the clearances shown here MUST be kept for
proper ventilation of the unit.
6
XZone_Manual.indd 6
1.75" (4.4cm)
XZone4 Installation Manual
Installation
Step 1. Mounting the XZone4
The XZone4 comes with a pair of rack mount ears,
that allows XZone4 to be mounted in any of the four ways:
1. Table Top Mount
Attach the four adhesive backed feet to the bottom of the chassis
2. Rack Mount
Attach the included rack mount ears to both sides of the unit as shown.
3. Under Cabinet Mount
Attach the included rack
mount ears to both sides of
the unit, with mounting holes
facing up as shown.
4. Wall Mount
Attach the included rack
mount ears to both sides of
the unit, with mounting holes
facing down as shown.
INSTALLATION OVERVIEW
Rack mount ear
4 Non-marking
adhesive rubber feet
Top of the unit
3/3/16 11:31 AM