Sony ixs-6600 Operation Manual page 67

Display on the Display on the
1st line 2nd line
FAN ERR x UNIT FAIL
x RUN HOURS
OVER
TEMP ERR HIGH
XPT ERR INxxx-OUTxxx
OPTION FRONT SLOTxx 1/2/3/4/5/6/7
BD.ERR
REAR SLOTxx
S-BUS CPU MAINx FAIL
ERR
BACKUPx FAIL A/B/C
a) The IXS-6600 has only one WORD SYNC IN connector, but the input
signal is divided into two lines of A and B in the unit.
b) A2 and B2 are not displayed on the IXS-6600. Power unit A and B of the
IXS-6600 are displayed as A1 and B1 in the display window, respectively.
c) On the IXS-6600, 5, 6, and 7 are not displayed.
d) The displayed slot number corresponds to the input or output slot number
on the rear panel of the IXS-6600/6700 as shown below.
Slot number IXS-6700 IXS-6600
1 OUT1 OUT1
2 OUT2 OUT2
3 IN1 IN1
4 IN2 IN2
5 OUT3 OUT3
6 OUT4 OUT4
7 IN3 IN3
8 IN4 IN4
9 OUT5 --
10 OUT6 --
11 IN5 --
12 IN6 --
13 OUT7 --
14 OUT8 --
15 IN7 --
16 IN8 --
Word in "x" Meaning
L/R • One or more fan units stop or
rotation speed exceeds the
defined value.
L/R • The elapsed time of the fan unit
is past the defined time for
periodic replacement.
— • Internal temperature exceeds
the defined value.
Input and output • There is a problem with the
connector crosspoint.
number
c)
• There is a problem with the
optional front board inserted in
the unit.
• The slot where the board is
inserted is not correct.
1/2/3/4/5/6/7/8/ • There is a problem with the
9/10/11/12/13/ optional rear board inserted in
d)
14/15/16 the unit.
• The slot where the board is
inserted is not correct.
A/B/C • There is a problem with the S-
BUS CPUx on the main CPU
board.
• There is a problem with the S-
BUS CPUx on the backup CPU
board.
Countermeasures
• Replace any defective fan units.
• Replace the fan unit indicated by
OVER.
• Check the ambient temperature
and the ventilation condition of the
unit.
• Replace a defective optional
board.
• Replace a defective optional
board.
• Insert the board in the correct slot.
• Replace a defective optional
board.
• Insert the board in the correct slot.
• Replace the defective IF-844 board
on the main CA-65 board.
• Replace the defective IF-844 board
on the backup CA-65 board.
Error Indications and Countermeasures
67