Operation; Units Of Measurement; Safety; Intended Use - STIEBEL ELTRON DHB-E SLi Operation And Installation

operation

safety

f This symbol indicates that you have to do something. The ac- f
tion you need to take is described step by step.
1.3

units of measurement

Note

All measurements are given in mm unless stated oth-
erwise.
2. Safety
2.1

intended use

This device is intended to be used with instantaneous water heat-
ers DHB-E SLi, DHB-STi and HDB-E Si.
This appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-do-
mestic environment, e.g. in a small business, as long as it is used
in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
2.2

General safety instructions

CAUTION Burns
There is a risk of scalding at outlet tempera-
tures in excess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged
8 and up and persons with reduced physical,
sensory or mental capabilities or a lack of ex-
perience and know-how provided that they
are supervised or they have been instructed
on how to use the appliance safely and have
understood the resulting risks. Children must
never play with the appliance. Children must
never clean the appliance or perform user
maintenance unless they are supervised.
3.

appliance description

This hardwired remote control enables the user to operate the
instantaneous water heater exclusively via the remote control. The
data transfer between the hardwired remote control and the in-
stantaneous water heater occurs by means of the integral adapter
assembly and a cable.
3.1 Operation
The required DHW outlet temperature of the instantaneous water
heater can be selected via the temperature selector on the hard-
wired remote control.
www.stiebel-eltron.com
e l e c t r o n i c L C D
2
1
1 Selector
2 Setting range minimum
3 Setting range maximum
f Turn the temperature selector to the required temperature. f
At times, the outlet temperature of the instantaneous water
heater may differ from the set temperature.
Note
!
If the outlet temperature is not sufficiently high when the
draw-off valve is fully open and the temperature selector
is set to maximum, then more water is flowing through
the appliance than can be heated by the heating system
(appliance is at its output limit).
f Reduce the flow at the draw-off valve, this will allow f
the system to achieve the required temperature
again.
4.

cleaning, care and maintenance

f Never use abrasive or corrosive cleaning agents. A damp f
cloth is sufficient for cleaning the appliance.
5.

troubleshooting

See chapter "Troubleshooting" in the instantaneous water heater
instructions.
e l e c t r o n i c L C D
3
FB 1 LCD | 3