Removal Procedure - Gree GWH09QB-K3DNA6D Service Manual

Service Manual

11. Removal Procedure

11.1 Removal Procedure of Indoor Unit
Step
1. Remove filter assembly
Open the front panel. Push the left filter
and right filter until they are separate from
the groove on the front panel.
Remove the left filter and right filter
respectively.
2. Remove horizontal louver
Push out the axile bush on horizontal
louver. Bend the horizontal louver with
hand and then separate the horizontal
louver from the crankshaft of step motor
to remove it.
3. Remove panel and display
Screw off the 2 screws that are locking the
a
display board.
Separate the panel rotation shaft from
b
the groove fixing the front panel and then
removes the front panel.
Installation and Maintenance
Caution: discharge the refrigerant
completely before removal.
Procedure
Front panel
Left filter
Horizontal louver
B2/B4/B8 display
A6 display
Screws
Right filter
Groove
Location of step motor
Axile bush
Screws
A1 display
Front panel
Screws
Panel rotation
Groove
Front
case
Panel
71