Display; Installing And Replacing Backup Batteries - iHome iH402 Instruction Manual

When lit, indicates Alarm 1
is armed. If not lit,
Alarm 1 is not armed
When lit, indicates AM clock
or alarm time
Your new iHome Clock includes a battery backup system that will maintain the time and alarm
settings during a temporary power interruption.
1. Keep unit connected to AC power when changing batteries to avoid losing your settings.
2. Press on the battery door and slide to open and remove the battery door.
3. Check the correct polarity (+/-) markings in the battery compartment and install two "AA"
batteries (not included) to match the markings.
4. Replace the battery door.
NOTE: With batteries installed, the display backlight will turn off during a power failure but the
clock will continue to run and maintain your alarm settings.
Time display

Installing and Replacing Backup Batteries

Display

When lit, indicates Alarm 2
is armed. If not lit,
Alarm 2 is not armed
When lit, indicates PM clock
or alarm time
3
When flashing, indicates backup
batteries should be replaced