Screw Lamp In And Out; Connect To Power Supply; Operation Of The Device; Adjust Tilt Angle - walimex Daylight 150 Instruction Manual

2. Demount
Screw out the lamp (see Screw the lamp in and out)
Open the screws, turn off the standard reflector slightly and pull it
frontwards.
6.3

Screw lamp in and out

WARNING
Danger of cutting and splitting through breaking or bursting lamp
Don´t let the lamp fall down.
Don´t touch the lamps with bare hands. Just touch the lamp at the plastic
socket or wear clean cotton gloves or use a clean cloth.
ADVICE:
Possible discolouration through burn marks on the lamps.
1. Switch off device.
See Switch the device on and off.
2. Disconnect from power supply:
Plug out power cord.
3. Let the device cool down.
CAUTION! Danger of burning on lamps. Let the device cool down for
approx. 10 minutes.
4. Screw in lamp:
Screw in the lamp carefully.
WARNING! Danger of electric shock. Always screw in the lamp as to
avoid touching in the socket, when the device is switched on.
5. Screw out lamp:
Screw out the lamp carefully and store it securely.
6.4

Connect to power supply

1. Switch off device.
See Switch the device on and off.
2. Compare the local power supply with the connected load of the device.
See Technical specifications.
11
If the values differ, please contact info@foto-walser.de or tel. +49 84 32
/ 9489-0.
3. Connect the power cord with the socket on the device and with the
power socket.
7.

Operation of the device

7.1

Adjust tilt angle

1. Loose locking screw for tilt lever.
2. Adjust required tilt angle.
3. Tighten locking screw for tilt lever.
7.2

Switch device and lamp on and off

The lamp can be switched on and off through the On/Off tappet switch.
1. Switch on device and lamp:
Set On/Off tappet switch on I.
The lamp lights up.
2. Switch off device and lamp:
Set On/Off tappet switch on O.
The lamp will go out.
8.

Transportation and storage

1. Switch off device.
See Switch the device on and off.
2. Let the device cool down completely.
WARNING! Danger of burning through hot parts. Let the device cool
down completely.
3. Screw out the lamp and store it securely.
See Screw the lamp in and out.
4. Demount power cord.
12