Blade Alignment - Sapir SP 1810 RN Instruction Manual

To reduce the risk of burns, electrocution, fire or injury to persons:
· Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
· This appliance should never be left unattended when plugged in.
· Close supervision is necessary when this appliance is used by, on, or near children or
invalids.
· Never operate this appliance if it has a damaged cord or plug or if it is not working
properly.
· Keep the cord away from heated surfaces.
· Do not pull, twist ,or wrap a line cord around the appliance
· Never drop or insert any object into any opening on this appliance
· Before use, make sure certain blades are aligned properly.
· Do not place the appliance on any surface while it is operating.
· Do not use this appliance with a damaged or broken comb nor with teeth missing from
the blades as injury may occur.

BLADE ALIGNMENT

· Your Clippers were carefully examined to ensure
that the blade were oiled and aligned before
leaving our factory.
· Blades must be realigned if they have been
removed for cleaning or replacement.
· To realign the blades, simple match the upper and
bottom blades teeth up, point for point. (End of top
blade teeth should be approximately 1.2mm back from bottom blade. Compare your
clipper blade with the sketch)
· If blade alignment is correct, add a few drops of oil to the blades,
turn clipper on for a few moments, turn off and unplug. Loosen
screws slightly and adjust. Tighten the screws after blade is
aligned.
OIL
· To maintain your clipper in peak condition, the blades should
be oiled every few haircuts.
· Do not use hair oil, grease oil mixed with kerosene or any
solvent, as the solvent will evaporate and leave the thick oil
which may slow down the blades motion.