Page 2
Chapter 1. DX-401A Instruction 1-1 Feature Maximum 10A per channel, total 30A! DMX 512 signal. 2 sets of signal input/output, either 3 pin XLR connector or RJ11 telephone jack. LED display. Automatic warm up function, protects loads and extend the life of bulbs.
Page 3
CONTROL 10A PER CHANNEL MAX 10A PER CHANNEL MAX DMX OUT DMX IN DMX OUT DMX IN 4CH. DMX DIMMER PACK DX-401A 4CH. DMX DIMMER PACK DX-402A 10A PER CHANNEL 10A PER CHANNEL FNC DMX MAIN AC IN 100-120V AC IN 100-120V CH.3.4...
Page 4
1-4 Wiring CAUTION: The wire & connectors used must follow the local government and other applicable rules and electrical regulations! 12 AWG : 20A 14 AWG : 15A 16 AWG : 13A 18 AWG : 10A www.carlosmendoza.com.mx...
Page 5
【▲】: move 1 number forward : up to Channel 512 【▼】: move 1 number backward :down to Channel 1 DX-401A /DX-402A is a 4 channel dimmer pack so when setting this unit: as d. 0 0 1, the output is from Channel 1 Channel 4.
Page 6
STEP-3 press【FNC】key to select channel STEP-4 press【▲】or【▼】to select dimming mode or switching mode (dimming) (Switching) warm up setting (0…6%) STEP-1 press【FNC】key STEP-2 press【FNC】key to select the setting channel, EX :select channel 1 STEP-3 press【▲】,【▼】key to adjust Channel 1 set on 6% for warm up 2-5 By pass Full On STEP-1 Selecting the channel for instant play :...
Page 7
ex.:(【▲】 Channel increasing 【▼】 Channel decreasing) showing the brightness of the selected channel Showing channel 1, 68%. Press【DMX】key to cancel the setting. DMX ADDRERSS will be displayed automatically after 10 minutes. 2-7 Dimming manually by fader (DX-402A) ex.: Adjust the【VR-1 ~VR-4】, you can dim the Channel 1~ Channel 4 directly. P.S.
Need help?
Do you have a question about the DX-401A and is the answer not in the manual?
Questions and answers