Comtrend Corporation WD-1030 Quick Install Manual

Ac1200 wireless usb adapter

Hide thumbs Also See for WD-1030:

Initial Installation

In order for your computer to recognize the USB Adapter, a driver is mandatory and also a configuration utility is

available.

1. Insert the Installation CD into the CD/DVD drive of your computer, and run the 'Setup.exe' program. The

description below is based on Windows XP operating system.

(Note: On a Windows 7/Windows 8 computer, you may see a UAC (User Account Control) window popup to warn

you that this program is going to make changes to your computer, click 'Yes' to continue).

2. Read the end user license agreement and click 'I accept the terms of the license agreement' and 'Next' to

accept the license agreement.

3. Choose 'Install driver only'. Click 'Next' to continue.

(For Comtrend Utility installation & descriptions – Please see the User Manual)

Page 1

Table of Contents

Do you have a question about the WD-1030 and is the answer not in the manual?

Page 1 Quick Install Guide WD-1030| AC1200 Wireless USB Adapter Initial Installation In order for your computer to recognize the USB Adapter, a driver is mandatory and also a configuration utility is available. 1. Insert the Installation CD into the CD/DVD drive of your computer, and run the ‘Setup.exe’ program. The description below is based on Windows XP operating system.
Page 2 4. Click ‘Install’ to begin the installation. 5. If you see this message below, click ‘Install this driver software anyway’ to continue. 6. Please be patient while installation is in progress, this may require a few minutes. 7. When you see this message, please click ‘Finish’ to complete the installation process. Page 2...
Page 3 8. Insert the USB Wireless Adapter into an available port (USB 3.0 preferable) on your PC/laptop. Manual WiFi Connection Setup Note: If your wireless router/access point supports Wi-Fi Protected Setup (WPS) then please skip steps 9-11 and refer to steps 12-13 to connect your wireless adapter to your wireless router/access point. 9.
Page 4 Note: Please check the instructions for your wireless router/access point for how long you need to hold down its WPS button to activate WPS. 13. Within two minutes, press and hold the WPS button for 5 seconds on the WD-1030 to activate its WPS. The devices will establish a connection.