Quickie QM710 Instructions For Use Manual page 30

7.7.2 Return to drive mode
Press the "Mode" button one or more times until a
standard display image with speed indicator appears in
the LCD control panel display.
7.7.3 Saving a new position to memory
1. Remove the rear cover of the backrest and connect
a Switch with a 3,5mm Jack to the socket on the 12V
potentiometer power supply box, (Fig. 7.7).
2. Press the "Mode" button one or more times until a
seat icon appears in the LCD control panel display,
(Fig.7.8).
3. Move the joystick to the left or right to select a
memory seat position (Seating, Stand-Up, Lie-Down,
Transfer, Relax or Custom Position), (Fig.7.9). A seat
icon and the memory description for the relevant
position are shown in the LCD control panel display.
4. Move and hold the joystick forwards, (Fig.7.9). The
seat adjusts to the factory preset position. The
movement can be stopped at any time and started
again when moving the Joystick forward.
5. Stop the seat movement where required and select
with a left or right Joystick movement the seat
actuator that needs to be changed.
6. Move the joystick forward or backwards until the
required position is reached. Select other actuators if
required and move them where need.
7. Move the Joystick left or right until the factory Memory
position is reached and where the new position shall
be programmed in.
8. Press and hold the Switch connected to the 12V
potentiometer power supply box, (Fig.7.10) and pull
the joystick backwards for 3 seconds until a beep can
be heard.
9. Release the Joystick and the button. Your new
required position is now stored and the actuators will
stop always in this new programmed end position.
30
Jive Up / QM-710 Stand Up
Fig.7.7
Fig.7.8
Fig.7.9
Fig.7.10
Rev.2.0