Scanning; Scanning Information - Viessmann VITOPEND Operating Instructions Manual

Scanning

Scanning information

Subject to the connected components
and settings made, you can scan current
temperatures and operating conditions.
Press the following keys:
1. for settings; "
2. for " ".
3. OK to confirm.
4. / for the required information.
5. OK to confirm; if you want to reset
the value to "0" (see following
table), " " flashes.
The information appears in the following sequence:
Display Explanation
0 0 Boiler number
1 15 °C Outside temperature
3 65 °C Boiler water temperature --
5 50 °C DHW temperature
45 °C DHW temperature with
5□
solar operation
°C Temperature sensor /
53 50
54 50 °C Temperature sensor aÖ
6 70 °C Collector temperature
18
6. OK to confirm; the value is reset.
Example:
On the display, you can see the number
"3" which shows the boiler water temper-
ature. The current boiler water tempera-
" flashes. ture is 65 °C.
3
Note
The scan mode terminates automatically
after 30 min or if you press
¸
6 5
Notes
Displayed only on multi boiler sys-
tems.
Displayed only if an outside temper-
ature sensor is connected.
Displayed only if a DHW cylinder is
connected.
Displayed only if a solar thermal
system is connected.
Displayed only if the Viessmann
solar control module is available
and a third temperature sensor has
been connected.
Displayed only if the Viessmann
solar control module is available
and a fourth temperature sensor
has been connected.
Displayed only if a solar thermal
system is connected.
°C
.