Connecting the AP to the network
Connect the Ethernet port of the AP to an Ethernet port of an Ethernet switch for Internet or MAN access.
Verifying network connection for the fit AP
All settings of the fit AP are configured on the AC. Use the display wlan ap all command on the AC that
connects to the fit AP. If the AP status is R/M, the AP is connected to the network.
<AC> display wlan ap all
Total Number of APs configured
Total Number of configured APs connected : 1
Total Number of auto APs connected
State : I = Idle,
C = Config, R = Run,
--------------------------------------------------------------------------------
AP Name
--------------------------------------------------------------------------------
ap1
-------------------------------------------------------------------------------
Verifying network connection for the fat AP
Use the ping command on the fat AP to ping the uplink network device. If the ping operation succeeds,
the AP is connected to the network successfully.
AP Profiles
J = Join, JA = JoinAck,
KU = KeyUpdate, KC = KeyCfm
State Model
R/M
13
: 1
: 0
IL = ImageLoad
WA4320i-ACN
Serial-ID
210235A1GQB139000435