Installing The Ap; Mounting The Ap On A Wall - H3C WA4320i-ACN Installation Manual

Few obstacles such as wall and ceiling exist between AP and clients.
•
• The AP is far away from electronic devices (such as microwave oven) that may generate radio
frequency (RF) noise.
The AP does not hinder people's daily work and life.
•
The place is not water seeping, water soaking, and condensing.
•
• A lightning arrester (user supplied) is installed on the AP for cabling outdoors.
The ceiling for installing the AP must be less than 18 mm (0.71 in) in thickness, and can bear a load
•
of 5 kg (1 1.02 lb). H3C recommends that you reinforce the ceiling by using boards if the ceiling is
not strong enough.

Installing the AP

Mounting the AP on a wall

1. Align the screw hole in the AP bracket with the screw hole in the AP rear. Use the M4 × 10 screw
to secure the AP bracket to the AP.
Figure 4 Attaching the AP bracket to the AP rear
2. Mark the installation holes on the wall by using the mounting bracket, as shown in
6
Figure 5.