Removing Packaging Reinforcement; Appropriate Installation Location; Removing The Transportation Locks - Beko WTE 6531 X0 User Manual

2 Installation
Refer to the nearest Authorised Service Agent for
installation of the product. To make the product ready
for use, review the information in the user manual
and make sure that the electricity, tap water supply
and water drainage systems are appropriate before
calling the Authorized Service Agent. If they are not,
call a qualified technician and plumber to have any
necessary arrangements carried out.
C
NOTE :
Preparation of the location and
electrical, tap water and waste water installations
at the place of installation is under customer's
responsibility.
NOTE :
Make sure that the water inlet and
discharge hoses as well as the power cable are
not folded, pinched or crushed while pushing the
product into its place after installation or cleaning
procedures.
B
DANGER:
Installation and electrical
connections of the product must be carried out by
the Authorized Service Agent. Manufacturer shall
not be held liable for damages that may arise
from procedures carried out by unauthorized
persons.
A
CAUTION:
Prior to installation, visually check
if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks
for your safety.

2.1 Appropriate installation location

• Place the machine on a rigid floor. Do not place it on
a long pile rug or similar surfaces.
• Total weight of the washing machine and the dryer
-with full load- when they are placed on top of each
other reaches to approx. 180 kilograms. Place the
product on a solid and flat floor that has sufficient
load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the edges
of other furniture.
5 / EN

2.2 Removing packaging reinforcement

Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement
by pulling the ribbon.

2.3 Removing the transportation locks

A
WARNING:
Do not remove the transportation
locks before taking out the packaging
reinforcement.
WARNING:
Remove the transportation safety
bolts before operating the washing machine!
Otherwise, the product will be damaged.
1. Loosen all the bolts with a suitable spanner until
they rotate freely (C) .
Washing Machine / User's Manual