Installation Procedure; Attaching The Remote Control Holder - Panasonic CN-DV1800EN Installation Instruction

Precautions
We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
Installation Procedure - Navigation System
Note: Disconnect the cable from the negative (–) battery terminal.
q
Attach the L-Shaped Brackets !0 on both
sides of the unit with the Tapping Screws
with Washers q.
!0 L-Shaped
Brackets
e
Secure the rear of the unit.
a) Check the electrical connections by
referring to this operating instructions.
b) Insert Power Connector t to the unit.

Attaching the Remote Control Holder

q
Attach the double-sided tape !4 to the back of the
Remote Control Holder u.
w
Remove the backing from the double-sided tape, then
press the Remote Control Holder u onto the surface
where you want to attach it.
e
Put the remote control i in the holder.
Note: Place the Remote Control Holder where it will not
interfere with driving.
6
w
q
Unit
w
Install the unit with Tapping Screws w.
t Power
Connector
e
w
r
After installation, reconnect the neg-
ative (–) battery terminal.
i Remote Control
Unit
u Remote Control
Holder
!4 Double-Sided
Tape
w Tapping
Screws
q Tapping
Screws with
washers
q
e
q
w