Advertisement
Preparation
¡Disconnect the lead from the negative (–) battery terminal.
Caution:
Do not disconnect the battery terminals of a car with trip or navigational computer since all user
settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
Installation Precautions
If possible, have the equipment installed by a professional installer.
If you should encounter any difficulties, please consult your nearest authorized Panasonic Service Centre.
1. This unit is designed exclusively for use in vehicles having a 12-volt negative ground battery system.
2. Follow the instructions for electrical connection carefully. Failure to do so may result in damage to the
unit.
3. Connect the power lead (red) after all other connections are made.
4. Be sure to connect the battery lead (yellow) to the positive (+) terminal of the battery or to the fuse
block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Carefully read the operating and installation instructions of the respective equipment before connecting
it to the unit.
Supplied Hardware
No.
Tapping Screws with Washers
q
(5 mm φ x 6 mm)
Tapping Screws
w
(5 mm φ x 16 mm)
e
Speed Pulse Cord (5 m)
r
GPS Antenna
t
Power Connector
y
RGB Cord
Remote Control Holder
u
4
Item
Diagram
Q'ty
No.
4
i
Remote Control Unit
4
o
Batteries (R6PU)
1
!0
L-Shaped Bracket
1
!1
Clip Type Connector
!2
L-Shaped Bracket
1
Cord Clamps
1
!3
(including Double-Sided Tape)
1
Double-Sided Tape
!4
Item
Diagram
Q'ty
1
2
2
4
1
3
1
- Quick Links:
- Installation Procedure
Hide quick links:
Advertisement
