Panasonic CN-DV1800EN Installation Instruction page 9

Cautions:
If noise is generated in proportion to engine revolutions, the earth conductor of the navigation power
cord and that of the monitor unit should be connected to the same place of the metallic block of the
car body. Take the same action if the brightness of navigation screen is not constant.
t Power Connector
Note: To connect any lead of the power connector to any lead of the vehicle wiring harness, cut off
the terminal and use the clamp type connector supplied instead.
Do not cut the speed pulse lead or the remote control lead.
Illumination lead (4m)
Orange/white
i j
Battery lead (5 m)
(Yellow)
Accessory lead (5 m)
(Red)
Ground lead (2m)
i Black j
Navi Mute lead (5m)
(Orange)
Infrared Receiver lead
(4 m)
(Black)
Speaker Cord (0.25 m)
Cut here
ILLUMINATION
!1 C lip Type Connector
5 A
BATTERY 5A
ACC
Panasonic
NAVI MUTE
RM-DATA
(Black/green)
SPEAKER
(Black)
To the power supply for
vehicle lighting
To the the vehicle battery,
continuous +12V DC
To ACC power, +12V DC
To clearn, bare metallic part of the
vehicle chassis
To NAVI Mute/Telephone Mute
of audio reciever
For use with Panasonic audio systems
provided with NAVI Mute function.
For details refer to the operating instructions
of your audio system.
Infrared Receiver (option)
This receiver is required to connect a monitor
other than Panasonic's.
Receiver lead (3 m)
Not Used
9