Main Unit - Panasonic DMP-BD10A Operating Instructions Manual

Main unit

!
Standby/on switch (Í/I) (➡ 12)
Press to switch the unit from on to standby mode or vice versa. In
standby mode, the unit is still consuming a small amount of
power.
Standby/on indicator (Í)
When the unit is connected to the AC mains supply, this indicator
lights up in standby mode and goes out when the unit is turned
on.
@
Disc tray (➡ 12)
#
Display
$
IIlumination lamp
Lights when the unit is turned on.
Using remote control
Batteries
Insert so the poles (i and j) match those in the remote control.
When closing the lid, insert it from the j (minus) side.
R6/LR6, AA
≥Do not use rechargeable type batteries.
≥Do not mix old and new batteries.
≥Do not use different types at the same time.
≥Do not heat or expose to flame.
≥Do not take apart or short circuit.
≥Do not attempt to recharge alkaline or manganese batteries.
≥Do not use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.

Getting started
OPEN/CLOSE
.
OPEN/CLOSE
%
Open/close disc tray (➡ 12)
^
Search / Skip
Search: Press and hold
Skip: Press
&
Stop (➡ 12)
*
Pause (➡ 12)
(
Start play (➡ 12)
Rear panel terminals (➡ 8–10)
Use
Remote control signal sensor
20
20
30
30
7 m directly in front of the
unit
If you cannot operate the unit or television using the remote control
after changing the batteries, please re-enter the codes (➡ 11).
11 Control reference guide
RQT8966
7