The Remote Control Hand-Held Unit; Fitting The Batteries To The Remote Control - VTL TL2.5 Owner's Manual

The Remote Control Hand-held Unit

The Remote Control hand held unit which comes with this TL2.5, allows you to
perform some basic functions from the comfort of your seat:
•
Increase/decrease the Volume Control by pressing the up and down
arrows respectively on the remote control hand-held unit.
•
Set the system in mute or operate modes by pressing the
mute button on the remote control hand-held unit. This
is a toggle control that changes the operating state from
one to the other each time it is pressed.
If the TL2.5 is in mute, pressing the up arrow to increase the
volume will remove the mute to allow you to hear the change
of the volume adjustment. The volume down command will
not change the mute state.
When you first press the buttons on the remote control unit,
there is a delay of a few seconds (about 1-2 seconds) before
the TL2.5's completes the processing of the signal sent by the
remote. Wait for the response from the TL2.5 before pressing
another button on the remote unit. During this processing
period, selection of other remote functions will be ignored. If
more of one button is pressed at once then the remote will
perform no function. While the TL2.5 is in the warm up
mode, with the LED blinking, the TL2.5 will not be able to
react to commands from the hand held remote.
Fitting the Batteries to the Remote
Control
1.
The back cover of the remote control is a sliding cover
that is removable by pressing down on the arrow and
sliding the cover off in the direction of the arrow to reveal
the battery compartment. Remove the cover and put it
aside for re-installation later.
2.
Locate the battery holder and insert the two AA batteries (supplied) in the
marked positions, + to + and - to -.
TL2.5 Preamplifier Owner's Manual
VTL
6
MUTE
VOLUME
pure tube
REMOTE NP-2