Stihl FS 510 C Instruction Manual page 39

3
2
Remove the screw (3) from the
N
shutter.
Pull the shutter (2) out of the shroud.
N
Rotate the shutter (2) from the
N
summer position to the winter
position and refit it.
Secure the shutter in position with
N
the screw (3).
At temperatures between +10°C and
+20°C
The machine can normally be operated
in this temperature range with the
shutter (2) in the summer position.
Change the position of the shutter if
necessary.
FS 510 C, FS 560 C
At temperatures above +20°C
2
Always return the shutter (2) to the
N
summer position.
NOTICE
Do not operate the machine in the winter
position at temperatures above +20°C
because there is otherwise a risk of
engine running problems and
overheating.
At temperatures below -10°C
In extreme wintry conditions
Temperatures below -10°C
–
Powder or drifting snow
–
it is advisable to use the optional "cover
plate kit".
5
The cover plate kit contains the following
parts for converting the power tool:
4 Cover plate partially blanks off the
slots in the starter housing
5 Synthetic fabric filter element for the
air filter
Instructions for converting the
–
machine
After installing the cover plate kit:
Set the shutter (2) to the winter
N
position.
At temperatures above -10 °C
Remove the parts of the cover plate
N
kit and refit the standard parts for
summer operation.
Depending on the ambient temperature:
Set the shutter (2) to the summer or
N
winter position.
Cleaning the Air Filter
Loosen filter cover mounting
N
screws.
Remove the filter cover.
N
Clean away loose dirt from around
N
the filter (5) and inside the filter
cover.
English
2
4
37