Stihl FS 510 C Instruction Manual page 28

English
Securing the cutting attachment
Fit the 70 mm (2.8 in) diameter
N
thrust washer (4) – convex side
must face up.
Fit the guard ring (5) for brush
N
knives – opening must face up.
Block the shaft.
N
Screw on the nut (6)
N
counterclockwise and tighten it
down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Cutting Attachment
Block the shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
Mounting Shredder Blade 320-2
Check that the deflector on the
N
machine is approved for shredder
blades – if not, perform the next two
steps.
Remove grass shield with thrust
N
plate – if fitted.
Remove the non-approved
N
deflector.
Mount deflector for shredder blade.
N
26
Fit the 65 mm (2.6 in) diameter
N
thrust plate.
Seal the unused tapped holes with
N
plugs.
4
3
2
b
a
Place the shredder blade (1) in
N
position – the cutting edges must
point upwards.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
Fit the 70 mm (2.8 in) diameter
N
thrust washer (2) – convex side
must face up.
Fit the shredder blade guard ring (3)
N
– opening must face up.
Block the shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
1
Remove the tool used to block the shaft.
Removing the Cutting Attachment
Block the shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
If you intend to use a different
N
cutting attachment – remove the
shredder deflector.
Mounting circular saw blades 225
Check that the stop for circular saw
N
blades is already mounted to the
machine – if not, perform the next
two steps.
Remove grass shield – if fitted.
N
Remove deflector – if fitted.
N
Mount limit stop for circular saw
N
blades.
Fit the 65 mm (2.6 in) diameter
N
thrust plate.
Seal the unused tapped holes with
N
plugs.
FS 510 C, FS 560 C