Stihl FS 510 C Instruction Manual page 22

English
4
5
3
1
Position the lower clamp (1) against
N
the underside of the drive tube next
to the gearbox.
Position the upper clamp (4) on the
N
drive tube so that the lug (5)
engages the notch (3).
Hold both clamps steady in this
N
position.
Insert a screw into the hole marked
N
1 on the upper clamp (4) and wind it
only a few turns into the lower clamp
(1).
Insert a screw in each of the holes
N
marked 2, 3 and 4 and wind them
only a few turns into the lower
clamp.
20
Slide the clamps up against the
N
gearbox and engage the lug (5) in
the gearbox gap (arrows).
Hold both clamps in this position.
N
Screw home the screws in holes 1
N
and 2 as far as stop.
Tighten down the screws in holes 1
N
and 2 to a torque of 8 Nm.
Screw home the screws in holes 3
N
and 4 in that order and tighten them
down to a torque of 8 Nm.
– Mounting the shredder deflector
6
Position the shredder deflector on
N
the lower clamp with its concave
side facing the gearbox (6).
Insert the screws (7) and tighten
N
them down firmly.
– Plugs
9
6
8
Plugs (9) are available as special
accessories to help prevent dirt getting
into the unused tapped holes for the
deflector in the gearbox (6) and clamps
(8).
FS 510 C, FS 560 C