Operation; Operating And Indicating Elements; Automatic Channel Changing Function - MAGINON SC-1 WR Instruction Manual

5. Operation

Note:
• The transmission frequencies of the security camera and receiver have been facto-
ry preset. The security camera transmits on the frequency of one of the available four
reception channels of the receiver. After switch-on, the transmission channel of the
used security camera must be selected on the receiver. The transmission channel of
the security camera can be selected at the back of the receiver.

5.1. Operating and indicating elements

The front of the receiver contains two indicating panels (K) and (L) and a button (M) for
changing the reception channels. The selected reception channel 1-4 is lit up in the indicating
(K) (L)

5.2. Automatic channel changing function

The radio monitoring facility can be extended by a further three cameras. Each camera must
transmit to another channel (1-4).
12
panel (K). The left LED (very left on page) is reception
(M)
channel 1.
The automatic channel change function is active if
the LED of the small indicating panel (L) is lit.
By pressing the CH SELECT (M) button, the reception
channels 1-4 are selected in sequence after which the
automatic channel changing function is activated.
By pressing the button again, the automatic chan-
nel changing function is switched off and reception
channel 1 is displayed again.