Installation Of Security Camera; Fitting Stand To Camera; Marking For Drilling - MAGINON SC-1 WR Instruction Manual

4.2. Installation of security camera

Install the security camera in such a way that no sun light falls onto the lens. The stand can be
connected to the underside or rear of the camera, depending on whether the camera is to be
wall or ceiling mounted.

4.2.1. Fitting stand to camera

(B)
(A)
Screw the retaining screw (A) of the stand into one
of the two threaded holes (B) and secure the stand
(C)
by tightening the clamping nut (C) against the
housing of the security camera.
(D)
(E)
Note:
• When selecting the installation site ensure that a mains socket is in close proximity. The
connecting cables of the power supplies each have a length of approx. 4.9 feet.

4.2.2. Marking for drilling

Hold the base plate (D) of the stand against the surface of the selected place of installation and
mark the location of the four holes (E) on the surface through the base plate.
Note:
• Caution! Prior to drilling ensure that no pipes are located behind the wall!
8