Preparing Milk Froth; Maintenance And Daily Cleaning - Siemens TE 502 SERIES Instruction Manual

Preparing milk froth

Risk of burns
A
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can foam the milk first and then
dispense coffee, or foam the milk separately
and pour it onto the coffee.
The appliance must be ready for use with
the cleaned milk frother attached.
h
1. Press the button (11).
h
The button (11) flashes and the
appliance now heats up for approx. 20
seconds. The display then shows
.
milk frother
2. Immerse the milk frother so that it
reaches the bottom of a cup or glass
that is one-third filled with milk.
3. Pull the milk frother (6) to open it.
Risk of scalding
A
Splashes of milk can scald. Carefully open
the milk frother (6). Do not touch the outlet
or aim it at anyone. The milk frother (6)
gets very hot. Hold the milk frother (6) by
the plastic part only. After use, allow to cool
down first before touching. Use this appli-
ance only after the milk frother (6) has been
fully assembled and installed.
4. Close milk frother (6) by pushing it in.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the
programme.
system
Maintenance and
daily cleaning
A
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
● Do not use abrasive cloths or cleaning
Pull
● Always remove any limescale, coffee, milk
● New sponge cloths may contain salts.
● Pull the drip tray (8c) with the coffee
● Remove drawer (4) and clean.
Rinse milk
Risk of electric shock
soft, damp cloth.
agents.
or descaling fluid residue immediately.
Such residue can cause corrosion.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
grounds container (8b) forward and out.
Remove the panel (8a) and the grate
(8d). Empty and clean the drip tray and
coffee grounds container.
en
11