Attaching A Trailer; Pushing The Tractor By Hand; Stopping The Tractor And Engine; Adjusting Mower Cutting Height - Allis-Chalmers ac130 series Operator's Manual

Pushing the Tractor by Hand

1. Disengage the PTO and turn the engine off .
2. Push the lever approximately 2.3/8" (6 cm) to release
the transmission (B, Figure 3).
3. The tractor can now be pushed by hand.
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age.
• Do not use another vehicle to push or pull
this unit.
• Do not actuate the transmission release
valve lever while the engine is running.
A

Adjusting Mower Cutting Height

The cutting height lift lever (A, Figure 4) controls the
mower cutting height. The cutting height has seven posi-
tions between 1.5" and 4.0" (3,8 and 10,2 cm).
en
B
Figure 3
A
Figure 4

Attaching a Trailer

The maximum horizontal drawbar force allowed is 280
Newton. The maximum vertical drawbar force is 160
Newton. This equates to a 250 lbs (113 kg) trailer on a 10
degree hill. Secure the trailer with an appropriately sized
clevis pin (A, Figure 5) and clip (B).
A
B

Stopping the Tractor and Engine

WARNING
Fuel and its vapors are extremely
fl ammable and explosive.
Fire or explosion can cause severe burns
or death.
• Do not choke the carburetor to stop engine.
1. Return the ground speed control(s) to NEUTRAL.
2. Disengage the PTO and wait for all moving parts to
stop.
3. Move the throttle/choke control to the SLOW position.
4. Turn the ignition key to OFF. Remove the key.
OPERATION
1 m
(3 pies
4 pulg.)
6 m (20 pies)
Figure 5
15