Part Ii: Getting Started; Parts Description; Assembling The Finder Scope - SKY-WATCHER Quattro-200 ST Instruction Manual

Part II: Getting Started

Parts description

When unpacking the box, you will find the following parts enclosed:
1. The main tube
2. 1 1/4 inch screwed on 42mm T2 adapter (left part (see Fig.2 page 6)) and 2 inch eyepiece
adapter (right part), to insert into the focuser's drawtube.
3. Finder bracket and 8x50 finder scope, with centering O-ring attached to the bracket.
4. Protective cap for the 1:10 speed reduction's knob.

Assembling the finder scope

1. Carefully remove the rubber O-ring from the finder scope bracket. Position the O-ring into
the groove on the finder scope tube.
2. Loosen the two adjusting screws on the bracket. Position the finder scope into its bracket
by sliding it backwards until the rubber O-ring seats. The chrome button on the finder
bracket contains a spring. When inserting the finder scope in the bracket, pull the chrome
button.
Slide the finder scope bracket into the mounting slot on the telescope and tighten the screw
to hold the bracket in place
Part II: Getting Started
3